Wednesday, March 20, 2024  |   Email

Send this article to a friend

Your Name	Required
Your Email	Required Invalid e-mail
Friend's Email	Required Invalid e-mail
Message
	You have 250 characters remaining for your message.

  Print

We are pleased to announce the release of an all-new CAN module, Zeus-Link™. Zeus-Link™ is an all-inclusive gauge interface unit that can connect to Holley ECU’s (Dominator, HP, Terminator X, Terminator X Max, Sniper and Sniper II) and to GM OBDII ports, reading vehicle data from CAN BUS to drive any Classic Instruments gauges accurately. Additional pass-through CAN port connection for other CAN devices. Customers can connect up to 6 standard gauges and 2 auxiliary gauges using all sender inputs or none. All instruments can be driven traditionally if the vehicle ECU does not support an output the driver wants to monitor. The unit features warning and check engine light outputs, dash light connection and on-board diagnostic lights to give status of power, BLE, and data. For maximum compatibility with Holley products, there is an additional resistor available if there are other CAN devices on the same harness and the Holley harness has an additional Holley ECU connector for other devices.

The entire unit is setup and managed through an app available on the App Store® or Google Play®. Configure which gauges are in the dash, how each gets its signal, view values being received by Zeus-Link™, and verify correct outputs and wiring all through the app. This new CAN module from Classic Instruments can be purchased direct or through any one of our authorized dealers

or at holley.com.